gaqob.blogg.se - Com5 putty download

The debug firmware prevents the device from doing anything for 15 seconds to give time for you to connect to the serial port.

After you know the device is connected, click open. Wait about 2-3 seconds or when you hear the "device connected sound" in windows. Do not click open yet. Unplug and re-plug in the device. Change the COM port to the device you figured out in the previous step (for me it was COM5). Open the PuTTY application and change the connection type to Serial. (It might say Arduino Leonardo, it might say something else but regardless it's always the connection when you plug it in) Yours will probably be different so remember it. Open "Device Manager" and under "ports" you'll find your device when you plug it in with a COM(Number). PuTTY is a powerful windows terminal program. This firmware should not be used with deej as it will most likely cause problems. This firmware includes more serial outputs to better determine issues. The goal is to read the outputs from the device through serial communication.ĭownload the debug version of the Pikatea Firmware (Pikatea_Macropad_GB2_1.2.2-debug.hex) and use this guide to flash the device with it. This guide applies to windows only but suggestions for Mac are included. The BIOS has two provision coverage ratio (PCR) banks and provides options to select SHA-1 or SHA256 for these banks.If you are having issues with your Pikatea Macropad, this guide will help to figure out if the problem is with the device or on the operating side. Trusted computing The BIOS provides options to enable or disable trusted platform module (TPM) security. 1 G, only with Intel Dual Speed 10/1 G Optic on SFP+ ports.

Two small form-factor pluggable (SFP) or SFP+ ports that support the following configurations:.

Note: If the BIOS must support USB 2.0 devices, or legacy USB devices, leave theīecause the system is connected using the universal asynchronous receiver-transmitter (UART) console, a traditional keyboard or mouse is not connected to the USB ports. To adjust this setting, access the BIOS setup screen and use the arrow keys to select the USB 3.0 To support universal serial bus (USB) 3.0 in operating systems, set the extensible host controller interface (xHCI)Įnabled. Example of VEP1425 system boot order screen To access the boot order setting from theįigure 5. Dell EMC VEP1405 BIOS main screenīoot order The BIOS looks for a bootable image in the Boot order setting list.

Using the arrow keys, select the Main tab.įigure 4.

From the Setup Prompt Timeout field, use the keyboard to enter the time.

Dell EMC VEP1405 setup prompt timeout screen

Using the arrow keys on the keyboard, select the Boot tab.įigure 3.

Note: By default, the ability to enter the BIOS setup once the boot process starts, is set at three seconds.